MMDVM Duplex Hotspot Running WPSD 3.5" Nextion Screen

The newest in our line of hotspots

From W1VET Electronics llc

Compare to others lower price and duplex

Others higher price and Simplex only

W1VET Electronics $245 DUPLEX

Other Simplex $290 and no screen

Other Simplex $368

Other Simplex $425

This is Duplex Hotspot running WPSD software. Now you can switch back and forth between talk groups easyer, work more servers without needing other hotspots or doing the hard config work (TGIF, BM, DMR+, FreeDMR, and more) you can use both time slot your way on DMR.

This Hotspot can be run as duplex or simplex whatever you would like.

Duplex MMDVM Hotspot UHF/VHF P25 DMR YSF D-Star M17 plus more. Running Raspberry Pi 3 B + with Touch Nextion 3.5" screen.

Running WPSD: (Latest version)

Raspberry Pi 3 B +

WPSD loaded on SD card you just need to configure your call and Wi-Fi (if you wish not to give out your SSID and Password) and other info than you're on the air.

Features:

• -Broadcom BCM2837B0, Cortex-A53 (ARMv8) 64-bit SoC @ 1.4GHz
• -1GB LPDDR2 SDRAM
• -2.4GHz and 5GHz IEEE 802.11.b/g/n/ac wireless LAN, Bluetooth 4.2, BLE
• -Gigabit Ethernet over USB 2.0 (maximum throughput 300 Mbps)
• -Extended 40-pin GPIO header
• -Full-size HDMI
• -4 USB 2.0 ports
• -CSI camera port for connecting a Raspberry Pi camera
• -DSI display port for connecting a Raspberry Pi touchscreen display
• -4-pole stereo output and composite video port
• -Micro SD port for loading your operating system and storing data
• -5V/2.5A DC power input
• -Power-over-Ethernet (PoE) support (requires separate PoE HAT)

-Duplex Hotspot

-Power wart and power wire

-Supports DMR, P-25, D-Star and System Fusion M17

-Fully tested

-Antennas

-Nextion 3.5" Screen

WIDELY COMPATIBLE: Supports DMR, P-25, D-Star and System Fusion

Differences in Duplex and Simplex: In Duplex mode, have 2 time slots, and Tx and Rx can do at the same time

Radio Frequency: In duplex mode, support 430-440 uhf, in simplex mode support both uhf 430-440MHz and vhf 140-150MHz

Best adjusted: TX =0, RX=0 need no offset.

Modem select: STM32-DVM/MMDVM_HS-Raspberry pi Hat (GPIO)

3D Printed Case: For high RF performance over metal case.

Antenna: On board two antennas and Touch Nextion 3.5" screen

30day warranty

Buyer pays return shipping

W1VET Electronics llc

www.w1vet.com