Each Hotspot is tested for 24 hours before and ready to config when you get it.
There are a lot of info on YouTube about duplex hotspots, take a look this will help with setup and the advantage of duplex.
or I can set it up for plug and play, just send me the info.
This great Pi 5 hotspot gives you room in the case for adding for build out like adding a SSD hard drive and board to use it for more things. Just add the board and SSD and program boot up from that and use it like a computer or put the SD card back in and run it as a hotspot again (a little config on your side will be needed). This Pi 5 also has a built in LED and fan to help heat and a and keep it cool case is well built and smoked top so you can see in from the top. This also has a safe on/off button built in to the Pi 5 to preform as safe start up and stop with out having to go into the Pi-star menu.
There is no other Hotspot on the market that runs Duplex on a Pi 5
The top-of-the-line HS from W1VET Electronics and Duplex is the way to go, hear 2 talk groups at the same time and never miss a call from them.
Others charge a lot for simplex hotspot and smaller and slower Raspberry Pi b step up to the next level.
Pi 5 4gb Features:
Video Core VII GPU, supporting OpenGL ES 3.1, Vulkan 1.2
Dual 4Kp60 HDMI® display output with HDR support
4Kp60 HEVC decoder
LPDDR4X-4267 SDRAM (4GB or 8GB)
Dual-band 802.11ac Wi-Fi®
Bluetooth 5.0 / Bluetooth Low Energy (BLE)
microSD card slot, with support for high-speed SDR104 mode
2 × USB 3.0 ports, supporting simultaneous 5Gbps operation
2 × USB 2.0 ports
Gigabit Ethernet, with PoE+ support
(requires separate PoE+ HAT)
2 × 4-lane MIPI camera/display transceivers
PCIe 2.0 x1 interface for fast peripherals
(requires separate M.2 HAT or other adapter)
5V/5A DC power via USB-C, with Power Delivery support
Raspberry Pi standard 40-pin header
Real-time clock (RTC), powered from external battery (battery sold separately)
Built on a Pi 5 4GB
latest firmware from WSPD
A LARGE 4.3" colorful Display
The default bit error rate on radio is less than 5%, and the default offset is 0. If the bit error rate is more than 5%, as long as the signal can be received, it can be corrected by offset.
This Hotspot is running the WPSD.
Set Controller Mode: Duplex
Radio Frequency: Freq:144-148,219-225, (Main Band)420-475,842-950
Duplex Mode: Example: RX:438.000000 TX:433.000000
Duplex Mode: Example: RX:145.000000 TX:433.000000
Setup On Duplex: RX:432.900000 TX:439.900000
Radio/Modem Type:STM32-DVM/MMDVM_HS-Raspberry pi Hat (GPIO) or any other (GPIO board)
option don't need now; some old board need set)
Admin->Expert->Edit MMDVMHOST->RXOFFSET=0 TXOFFSET=0 (default value in pistar)
(update:2019/2 new 3225 TCXO so offset is 0)
Included:
1 Hotspot
1 Power Cube
1 Power cable usb C
1 SD card loaded system WPSD
If you like I can load your SSID and password for your Wi-Fi to make your setup of personal in much Ezer as well.
w1vet electronics has the best customer service around
S# taken and other info before shipment